1.Static Sun Electric & Solar
19033 S Arizona Ave U1, Chandler, AZ 85286, USA
Editorial by Andre Caçador, Founder of Hero365 · Sources: Google Places · Last updated Oct 3, 2026
19033 S Arizona Ave U1, Chandler, AZ 85286, USA
1191 S Crossbow Pl, Chandler, AZ 85286, USA
797 S Jesse St, Chandler, AZ 85225, USA
560 S Pineview Dr, Chandler, AZ 85226, USA
123 E Chandler Heights Rd, Chandler, AZ 85248, USA
110 N Senate Way, Chandler, AZ 85225, USA
4960 S Gilbert Rd Ste 1-466, Chandler, AZ 85249, USA
5460 W Kesler Ln, Chandler, AZ 85226, USA
17 S Roosevelt Ave, Chandler, AZ 85226, USA
1710 E Germann Rd #14A, Chandler, AZ 85286, USA
24440 S. 122nd St, Chandler, AZ 85249, USA
4330 W Chandler Blvd #1, Chandler, AZ 85226, USA
100 S Hamilton St, Chandler, AZ 85225, USA
910 N Alma School Rd, Chandler, AZ 85224, USA
3100 W Ray Rd, Chandler, AZ 85226, USA
4141 S Arizona Ave, Chandler, AZ 85248, USA
1155 W Chandler Blvd, Chandler, AZ 85224, USA
650 N 54th St, Chandler, AZ 85226, USA
1825 E Germann Rd, Chandler, AZ 85286, USA
5 S Roosevelt Ave, Chandler, AZ 85226, USA
11 S Roosevelt Ave, Chandler, AZ 85226, USA
2530 E Germann Rd, Chandler, AZ 85286, USA
Pricing in the Phoenix metro, which includes Chandler, is moderate by national standards. Demand from new construction, solar and EV installs keeps good electricians busy, so the cheapest bid is rarely the best one. The following are typical ranges drawn from publicly available regional cost guides. They are not quotes, and your job will vary. A diagnostic or service call usually runs $75 to $200, often credited toward the repair if you proceed. Hourly rates for licensed electricians commonly fall between $90 and $150. Replacing a standard outlet or switch is roughly $100 to $250 each, and a GFCI outlet $150 to $350. A ceiling fan on an existing fan-rated box is about $150 to $400. Recessed lights run $150 to $350 per fixture. Whole-home surge protection is typically $300 to $900. A Level 2 EV charger circuit usually lands between $600 and $2,000 depending on panel capacity and the distance from panel to garage, with the charger itself extra. A 200-amp service panel upgrade commonly costs $2,500 to $5,500 including permit and utility coordination, and more if the meter has to be relocated or the home needs 400 amps. A full rewire of an older home can run $8,000 to $20,000 or more. Attic work is a local cost factor, since summer attic temperatures can pass 130 degrees and some crews price that in or schedule early mornings. For anything beyond a simple swap, get two or three written quotes and ask whether the price is flat-rate or time-and-materials.
In Arizona, contractor licensing is handled by the state, not the city. The Arizona Registrar of Contractors (ROC) licenses electrical contractors. Residential work generally falls under the CR-11 classification, and commercial work under C-11. You can look up any license number, bond status, classification and complaint history for free on the ROC website at roc.az.gov. Arizona law requires contractors to show their license number in advertising and on contracts, so a company that dodges the question is waving a flag. The ROC also administers a Residential Contractors' Recovery Fund that can compensate homeowners harmed by a licensed contractor's violations. It applies only if the contractor was licensed, and payout limits apply, so check the ROC for current terms. Arizona's handyman exemption lets unlicensed people do small jobs under a low dollar threshold (currently $1,000 including labor and materials), but it does not cover work that requires a building permit. For permits, the City of Chandler's Development Services department issues and inspects electrical permits. As a rule of thumb, service and panel changes, new circuits, subpanels, EV charger circuits and solar interconnections need permits. Like-for-like replacement of a switch, outlet or light fixture typically does not. Chandler enforces a National Electrical Code edition with local amendments, so confirm current requirements with Development Services. The licensed contractor should pull the permit in their own name. If someone suggests skipping it to save money, that is the moment to find another electrician.
Start with the ROC lookup, not with Google reviews. Confirm the license is active, the classification covers residential electrical work (CR-11, or a dual license that includes it), the bond is in place, and there are no recent unresolved complaints. Match the name on the license to the name on the quote and truck. Next, ask who will actually be on site. Many Valley firms use subcontractors or apprentices, which is fine if a licensed electrician supervises and the company stands behind the work. Ask for a written, itemized estimate that lists the permit, materials such as panel brand and breaker type, and warranty terms. A one-year labor warranty is common, and longer is a good sign. Ask directly whether the price includes the permit and inspection. For panel work, ask whether they handle coordination with your utility. SRP serves most of Chandler, while APS serves some pockets, and the two have different processes. Be wary of door-to-door offers after monsoon storms, pressure to decide the same day, cash-only demands, and any estimate that comes in far below the others. For solar or EV jobs, ask how many similar installs they have done in Chandler and whether you can see a recent permit sign-off. A good electrician will explain why your panel needs an upgrade rather than just saying it does, and will tell you plainly when a repair is enough.
Chandler's housing stock explains most of the calls electricians get. Downtown and the older neighborhoods have homes from the 1960s through the 1980s. Depending on the year, you may find aluminum branch wiring (common in some mid-1960s to early-1970s builds), Federal Pacific or Zinsco panels now widely regarded as problem equipment, or 60 to 100 amp services that cannot handle central AC plus a modern kitchen. Many 1990s and 2000s subdivisions have 150 or 200 amp panels but face a different issue: heat. Attic temperatures in the Valley stress wire insulation, fixtures, and junction boxes, and bathroom fans, attic lights and AC disconnects tend to fail earlier than they would in a cooler climate. Outdoor equipment is another pattern. Pool pumps, backyard outlets, and AC disconnects take sun and dust exposure, and GFCI protection and weatherproof covers degrade over time. Monsoon season (mid-June through September) brings lightning, power surges and outages, which is why whole-home surge protection is a common upgrade. Finally, solar and EV charging are driving many panel upgrades. A home with an older 100 or 125 amp panel often cannot add solar and a Level 2 charger without a service upgrade or load management. If you are planning either, ask your electrician for a load calculation before you buy equipment.
Chandler homeowners increasingly call electricians for EV chargers and solar-ready panels, and the details matter. Most of Chandler is in SRP territory, with APS serving some areas, so check your utility bill to confirm which one is yours. Both offer time-of-use or EV-specific rate plans that can cut the cost of overnight charging. Terms change, so check the utility website before picking a plan. A properly installed charger is on a dedicated 240-volt circuit sized for the charger's amperage with continuous-load rules applied, and it needs a permit and inspection. Installers sometimes suggest a load management device instead of a full panel upgrade. This can save thousands if your panel has headroom, and it should be backed by a written load calculation, not a guess. For solar, the panel's busbar rating and main breaker size determine how much you can interconnect, and some older panels require replacement before the utility will approve the system. If you plan to dig a trench to a detached garage or backyard, Arizona's Blue Stake program (call 811 before digging) is required for underground utility locates. Reputable electricians will mention it before you ask. If a contractor says you can skip the inspection because the charger is just plugged in, that is not how the permit process is supposed to work, and your homeowner's insurance could treat unpermitted work as a problem if a claim ever arises.
Arizona's handyman exemption covers only small jobs under a low dollar threshold (currently $1,000 including labor and materials) and excludes work needing a permit. Panels, new circuits, EV chargers and solar interconnections all need permits, so they need a licensed contractor. Check the license at roc.az.gov before you sign anything.
For homes, look for the ROC residential electrical classification (CR-11) or a dual license that covers residential work. Commercial licenses (C-11) can also cover residential work in many cases. The ROC lookup shows the exact classifications, bond status and complaint history, and the license number should appear on the estimate and the truck.
A 200-amp service panel upgrade typically runs $2,500 to $5,500 in the Phoenix metro, including the permit. Meter relocation, trenching, an older home that needs a grounding upgrade, or a 400-amp service pushes the price higher. Get two or three itemized quotes and ask whether utility coordination with SRP or APS is included.
It depends on the build year. Homes from the mid-1960s to early 1970s may have aluminum branch wiring, and some older homes have Federal Pacific or Zinsco panels, which electricians commonly recommend replacing. Homes built from the 1990s on usually have copper wiring, but the heat in attics can still age it prematurely. A licensed electrician can inspect the panel and attic runs for a diagnostic fee, often $75 to $200.
Generally yes. A new 240-volt circuit is permitted work through the City of Chandler's Development Services department, and your electrician should pull the permit and schedule the inspection. Confirm current requirements with the city. Unpermitted work can complicate a home sale or an insurance claim down the road.
Many electricians recommend it because of monsoon lightning and the number of electronics in modern homes. It typically costs $300 to $900 installed, much less than replacing an AC control board, a pool controller and a few appliances. It will not stop a direct lightning strike, but it handles most utility-side surges.
Start by documenting the problem and giving the contractor a written chance to fix it. If that fails, file a complaint with the Arizona Registrar of Contractors, which can investigate licensed contractors and order corrections. The Residential Contractors' Recovery Fund may compensate eligible homeowners, with limits and conditions. Unlicensed contractors are not covered, which is one more reason to check the license first.
For contractors
Hero365 customers get pinned placement on this page, an AI receptionist that answers and books their calls 24/7, and a full AI back office — scheduling, estimates, invoicing — for $19.99/month.