1.The Plumbing House
63 Bluffwalk Dr, Garland, TX 75040, USA
Editorial by Andre Caçador, Founder of Hero365 · Sources: Google Places · Last updated Sep 24, 2026
63 Bluffwalk Dr, Garland, TX 75040, USA
3960 Broadway Blvd STE 220G, Garland, TX 75043, USA
675 Town Square Blvd Suite 200, Building 1A, Garland, TX 75040, USA
3313 Queenswood Ln, Garland, TX 75040, USA
3710 S Shiloh Rd, Garland, TX 75041, USA
950 W Centerville Rd, Garland, TX 75041, USA
1225 Belt Line Rd Ste 103A, Garland, TX 75040, USA
3238 Southern Dr #3052, Garland, TX 75043, USA
2914 National Ct, Garland, TX 75041, USA
627 Walnut Cir E, Garland, TX 75040, USA
633 N 5th St, Garland, TX 75040, USA
13509 Lyndon B Johnson Fwy Suite 200, Garland, TX 75041, USA
4901 Miami Dr, Garland, TX 75043, USA
1501 Kings Rd, Garland, TX 75042, USA
629 Walnut Cir E, Garland, TX 75040, USA
1229 Patricia Ln, Garland, TX 75042, USA
1829 Sage Dr, Garland, TX 75040, USA
3556 Miller Park Dr, Garland, TX 75042, USA
2622 National Pl, Garland, TX 75041, USA
2413 S Shiloh Rd, Garland, TX 75041, USA
1810 Commerce St, Garland, TX 75040, USA
Garland pricing tracks close to the broader DFW metro, usually running slightly under Dallas proper and above rural Collin County towns. A standard service call (diagnostic plus minor repair — a running toilet, a slow drain, a leaky fixture) typically lands between $150 and $400, per regional data aggregated by Angi's 2024-2025 cost guides. Water heater replacement runs $1,200-$2,600 for a standard 40-50 gallon tank, and $3,000-$5,500 if you're switching to tankless, which is common in newer North Garland builds with smaller utility closets. Slab leaks — a real issue here given the area's clay soil — run $1,800-$4,500 depending on whether the plumber reroutes the line through the attic or tunnels under the slab. Full sewer line replacement, often needed in homes near mature tree lines in Original Town Garland or Rowlett border neighborhoods, ranges $4,000-$12,000 depending on trenchless vs. dig-and-replace method and yard access. Always get two to three quotes on anything over $1,000 — the spread in Garland between the lowest and highest bid on the same slab leak repair can be 2x.
In Texas, all plumbing work — not just new construction — has to be performed or directly supervised by someone licensed through the Texas State Board of Plumbing Examiners (TSBPE), the state agency that issues Master and Journeyman Plumber licenses statewide. Ask for the license number and verify it directly on the TSBPE's public license lookup at tsbpe.texas.gov — this takes two minutes and catches unlicensed operators immediately. Separately, most plumbing jobs in Garland (water heater swaps, repipes, sewer line work, gas line alterations) require a permit from the City of Garland's Building Inspection Department, not just a state license. A licensed plumber who skips the city permit step is cutting a corner that becomes your problem at resale — unpermitted work is a common issue that surfaces during home inspections in Garland's older resale market. If a plumber tells you a permit isn't needed for a water heater replacement or sewer repair, that's worth double-checking with the city directly before you sign anything.
Beyond the TSBPE license number, ask three things: how long has the company held a physical Garland or DFW-metro address (not just a call center number), do they pull their own permits or expect you to, and will they give you a written, itemized estimate before starting work rather than a vague not-to-exceed figure. For slab leak or foundation-adjacent work specifically, ask whether they use acoustic/electronic leak detection before cutting into the slab — some outfits still guess-and-cut, which means more drywall and flooring repair than necessary. For water heater and repipe jobs, ask if the quote includes permit fees and final inspection, since those add $50-$150 in Garland and get left off lowball bids. Check reviews for pattern complaints (not just star ratings) — recurring mentions of 'came back to fix the same leak' or 'no permit pulled' are more useful signals than a 4.8 average.
Garland sits on the Eagle Ford shale/clay belt that runs through most of North Texas, and that clay expands significantly when wet and contracts when dry — the seasonal swing between a soaked spring and a baked August is enough to shift foundations and stress the copper or galvanized supply lines running underneath them. That's the direct cause behind Garland's above-average rate of slab leaks compared to newer, more stable-soil suburbs further north. Layered on top of that: large sections of Garland, particularly neighborhoods built between the 1950s and 1970s around Downtown, Duck Creek, and South Garland, still have original galvanized steel supply lines or clay/cast iron sewer laterals. Galvanized pipe internally corrodes and narrows over 50-70 years, which shows up as chronically low water pressure long before it fully fails. Clay sewer laterals in the same neighborhoods are magnets for root intrusion from mature trees — a sewer camera inspection before buying or after repeated backups is a smart $150-$300 spend that saves a much bigger bill later.
Garland homeowners got a hard lesson in February 2021 when Winter Storm Uri caused widespread pipe bursts across North Texas, and freeze risk hasn't gone away — DFW still sees multiple sub-freezing nights most winters. Pipes running through garages, exterior walls, or unheated additions (common in older Garland homes that were expanded room-by-room over decades) are the most exposed. A plumber worth hiring will flag exposed pipe runs during any service call and recommend insulation sleeves or heat tape before the first freeze, not just fix the burst pipe after the fact. If you're getting any plumbing work done in fall, ask the plumber to do a quick freeze-vulnerability walkthrough while they're already there — it's usually free or low-cost as an add-on and cheaper than an emergency call in January.
Go to the Texas State Board of Plumbing Examiners' public license search at tsbpe.texas.gov and enter the name or license number the plumber gives you. Every legitimate Master or Journeyman Plumber in Texas, including anyone working in Garland, has to hold a current TSBPE license — this is a state requirement, not a city one. If they can't produce a number or it doesn't show up active, don't hire them for anything beyond the most trivial fix.
Yes, generally. The City of Garland Building Inspection Department requires permits for water heater replacements, particularly when venting or gas line connections are involved, along with a final inspection. Reputable local plumbers build this into their quote; if a bid seems unusually low, ask directly whether it includes the permit and inspection or if that's an extra line item you'll be charged later.
In neighborhoods built in the 1950s-1970s (Original Town Garland, Duck Creek, parts of South Garland), original galvanized steel supply lines are common, and they narrow internally with corrosion over decades. Chronic low pressure — as opposed to a sudden drop, which suggests a leak — is a classic galvanized pipe symptom. A plumber can confirm with a simple pressure test and pipe material check; full or partial repipe (copper or PEX) typically runs $4,000-$10,000+ depending on home size.
Expect $1,800-$4,500 for a typical slab leak repair, varying by whether the plumber reroutes the line overhead through the attic (usually cheaper, less disruptive) or tunnels under the slab to access it directly. Garland's clay soil makes slab leaks more common here than in areas with more stable ground, so get a second opinion if the first quote jumps straight to full repipe without leak detection first.
Garland's water utility supplies moderately hard water typical of the North Texas/East Fork water supply system, which contributes to scale buildup in water heaters, tankless units, and fixtures over time. If you're on a tankless system, ask your plumber about a whole-home water softener or at minimum a sediment/scale filter — it extends the life of the unit and is a common recommendation for Garland homes on this supply.
A sewer camera inspection ($150-$300) is the direct way to check — it's a standard tool most Garland plumbers carry. Root intrusion into clay or cast iron sewer laterals is common in older, tree-lined Garland neighborhoods, and repeated backups in the same spot are a strong signal before you even call anyone. Trenchless pipe lining or bursting can often fix root-damaged sections without digging up the yard, usually for less than full replacement.
Garland doesn't get the sustained deep freezes of the northern U.S., but events like February 2021's Winter Storm Uri showed that even a few days below freezing can burst exposed pipes across the metro. Pipes in garages, exterior walls, and older room additions are the most at-risk. A cheap fix — foam insulation sleeves, around $1-$3 per pipe section — is worth doing before December if it hasn't been done already.
For contractors
Hero365 customers get pinned placement on this page, an AI receptionist that answers and books their calls 24/7, and a full AI back office — scheduling, estimates, invoicing — for $19.99/month.