1.Static Sun Electric & Solar
19033 S Arizona Ave U1, Chandler, AZ 85286, USA
Editorial by Andre Caçador, Founder of Hero365 · Sources: Google Places · Last updated Nov 2, 2026
19033 S Arizona Ave U1, Chandler, AZ 85286, USA
1191 S Crossbow Pl, Chandler, AZ 85286, USA
797 S Jesse St, Chandler, AZ 85225, USA
560 S Pineview Dr, Chandler, AZ 85226, USA
123 E Chandler Heights Rd, Chandler, AZ 85248, USA
110 N Senate Way, Chandler, AZ 85225, USA
4960 S Gilbert Rd Ste 1-466, Chandler, AZ 85249, USA
5460 W Kesler Ln, Chandler, AZ 85226, USA
17 S Roosevelt Ave, Chandler, AZ 85226, USA
1710 E Germann Rd #14A, Chandler, AZ 85286, USA
24440 S. 122nd St, Chandler, AZ 85249, USA
4330 W Chandler Blvd #1, Chandler, AZ 85226, USA
100 S Hamilton St, Chandler, AZ 85225, USA
910 N Alma School Rd, Chandler, AZ 85224, USA
3100 W Ray Rd, Chandler, AZ 85226, USA
4141 S Arizona Ave, Chandler, AZ 85248, USA
1155 W Chandler Blvd, Chandler, AZ 85224, USA
650 N 54th St, Chandler, AZ 85226, USA
1825 E Germann Rd, Chandler, AZ 85286, USA
5 S Roosevelt Ave, Chandler, AZ 85226, USA
11 S Roosevelt Ave, Chandler, AZ 85226, USA
2530 E Germann Rd, Chandler, AZ 85286, USA
Chandler pricing tracks the broader Phoenix metro. These are typical ranges, not quotes, and they shift with home age, attic access, and how busy contractors are, so get two or three written estimates before committing. Most licensed electricians charge a service-call or diagnostic fee of roughly $80 to $150, often credited toward the job if you proceed. Hourly rates for a journeyman-level tech commonly land between $90 and $150. Small jobs add up differently: replacing a standard outlet or GFCI usually runs $120 to $300, a ceiling fan install with existing wiring about $150 to $400, and a whole-house surge protector roughly $300 to $800 installed. Bigger projects vary more. A 200-amp panel replacement in the Phoenix area typically falls between $2,500 and $5,000, and can go higher if the meter base, service conductors, or utility coordination need work. A Level 2 EV charger on an existing 240-volt circuit often costs $800 to $2,500 installed, while running a new circuit from a panel at the far end of the house costs more. A subpanel for a garage or casita is commonly $1,200 to $3,000. Full rewires of older homes are rare in Chandler but can run well into five figures. Be wary of any quote that is dramatically below the others. In a market with this many licensed shops, a price far under the pack usually means skipped permits, an unlicensed worker, or a bait-and-switch once the panel cover comes off.
Arizona does not license electricians at the city level. Contractors are licensed by the Arizona Registrar of Contractors (ROC), and you can verify any license for free on the ROC website (roc.az.gov) by searching a business name or license number. Look for an active license in an electrical classification. Residential electrical work is generally covered by an R-11 or dual-classification CR-11 license, while commercial-only licenses are a different category. Confirm the classification on the ROC record rather than taking the contractor's word for it. The ROC record also shows bond status, complaint history, and any disciplinary actions. Arizona law carves out a limited exemption for very small jobs, commonly cited as under $1,000 in total labor and materials, but that exemption does not cover work that requires a permit. Most panel, circuit, EV charger, and service work will require one, so an unlicensed handyman is the wrong choice for those jobs. One benefit worth knowing is the ROC's Residential Contractors' Recovery Fund. If you hire a properly licensed contractor and the work is defective or abandoned, you may be able to file a claim for compensation after following the ROC's complaint process, with a per-claim cap that the ROC sets and updates. That protection generally does not apply if you hired an unlicensed person. Ask for the license number in writing on the estimate, and check that the name on the license matches the name on the invoice and the truck.
Permits for electrical work inside city limits go through Chandler's Development Services, which handles plan review and inspections. Typically you will need a permit for a panel or service upgrade, new circuits, a subpanel, an EV charger circuit, pool or spa wiring, and solar or battery interconnections. Like-for-like swaps such as replacing a switch, outlet, or light fixture usually do not. If you are unsure, call the city or ask your contractor which permit applies and who pulls it. The contractor should pull the permit under their own license, not ask you to pull it as an owner-builder. Owner-builder permits exist in Arizona but shift responsibility and liability to you, and a lot of homeowners do not realize that until a problem comes up. After the work, an inspector verifies it against the adopted National Electrical Code and Chandler's local amendments. Check with Development Services for the currently adopted NEC edition, since that affects things like GFCI and AFCI requirements and surge protection rules. If your property is served by SRP or APS, which depends on your address, a service upgrade usually involves coordination with the utility for disconnect and reconnect. Ask your electrician how they handle that scheduling, because it is a common source of delays. Keep the final permit sign-off in your records. It matters when you sell, insure, or add solar.
Heat is the main driver. Attic temperatures in the Valley cook wire insulation, and older nonmetallic cable can become brittle, especially near recessed lights and in spots where insulation was piled on later. If you see cracked sheathing, scorched junction boxes, or lights that flicker only on hot afternoons, get it checked. The 1970s and early 1980s homes near downtown Chandler and the older neighborhoods may still have original panels. Federal Pacific and Zinsco panels turn up in Arizona homes of that era and have well-documented breaker reliability concerns, so a licensed electrician should look at them. Aluminum branch wiring is less common but appears in some homes built in the late 1960s and early 1970s. Outdoors, UV and heat wear out exposed outlets, covers, and conduit fittings. Pools are everywhere in Chandler, which means bonding, GFCI protection, and equipment circuits deserve a look, especially after a previous owner's DIY work. Older homes can also lack enough capacity for modern AC replacements, EV chargers, and induction ranges, so a load calculation is worth requesting before adding any large circuit. Rodents are another local issue. Roof rats are common in neighborhoods with citrus and palms and can chew wiring in attics and around AC equipment. During monsoon season, dust, surges, and nearby lightning can damage electronics and breakers, which is why whole-house surge protection is a smart add-on here.
Start with the ROC lookup, then ask for a written, itemized estimate that lists the scope, the permit, the materials, and who is responsible for scheduling the inspection. A good electrician will explain what they found and why it needs fixing, and will show you photos of anything alarming in the panel or attic. Be skeptical of pressure to replace everything immediately without showing you the problem. Ask whether the person coming to your house is a licensed electrician or an apprentice working under one, and how the company handles warranty on labor. Many reputable shops give a one-year labor warranty, though terms differ, so get it in writing. Confirm they carry liability insurance and workers' compensation, and ask for proof if the job is large. For panel upgrades, ask whether the quote includes the meter base, grounding electrode system, new breakers, and surge protection, and whether utility coordination is included. For EV chargers, ask whether they have done a load calculation and whether your panel can support the circuit without an upgrade. For rental properties or older homes, ask about safety inspections that cover GFCI, AFCI, smoke alarm interconnection, and bonding. Finally, trust responsiveness. Contractors who answer calls, show up when promised, and explain their pricing before the work starts tend to be the ones who also do clean work behind the wall.
Yes, in nearly all cases. Panel replacements and service upgrades are permitted work in the City of Chandler and require an inspection by Development Services after installation. Your licensed electrician should pull the permit under their own ROC license. If the utility needs to disconnect and reconnect power, which is SRP or APS depending on your address, ask your contractor to coordinate that and give you a realistic timeline. Skipping the permit can cause problems with insurance claims and at resale.
Use the Arizona Registrar of Contractors license search at roc.az.gov. Enter the business name or license number and confirm the status is active, the classification covers residential electrical work (such as R-11 or CR-11), and the bond is current. The record also shows complaint history. Match the name on the license to the name on the estimate. Unlicensed work is a common issue in the Phoenix area, so this two-minute check is worth doing every time.
For a Level 2 charger on an existing 240-volt circuit or a short run from the panel, expect roughly $800 to $2,500 installed in the Phoenix metro. Costs rise if your panel is full, the garage is far from it, or a service upgrade is needed. Check with your utility, SRP or APS, for EV-specific rate plans and any current rebates, because those programs change. Get a load calculation before you buy a high-amperage charger.
It is common in Chandler. Air conditioners run almost continuously from May through September, and heat in attics and panels can reduce a breaker's tolerance. Repeated tripping can also mean an aging AC compressor, loose connections, or an overloaded circuit. Do not just swap in a larger breaker. A licensed electrician should test the circuit and check the AC's amperage draw, since an oversized breaker can create a fire hazard.
They can be. Both brands were installed in homes built roughly from the 1960s through the 1980s, and both have documented concerns about breakers failing to trip. Some newer parts of Chandler are too recent to have them, but older neighborhoods may. A licensed electrician can identify the panel brand in minutes. Many insurers and home inspectors flag them, so replacement is often recommended even if the panel seems to work normally.
It is a sensible, relatively cheap precaution. Monsoon season runs from mid-June through September, bringing lightning, power fluctuations, and outages that can damage electronics and appliances. A whole-house surge protector at the panel typically costs about $300 to $800 installed in the Phoenix area and is often installed alongside a panel upgrade. Point-of-use power strips still help for sensitive equipment, but they do not replace panel-level protection.
Only within narrow limits. Arizona has a small-job exemption, commonly cited at under $1,000 for labor and materials combined, but it does not cover work requiring a permit and has other restrictions. Panel work, new circuits, EV chargers, and pool wiring all typically require a licensed contractor. Hiring unlicensed help can also leave you without access to the ROC's recovery fund if something goes wrong, so verify the license first.
For contractors
Hero365 customers get pinned placement on this page, an AI receptionist that answers and books their calls 24/7, and a full AI back office — scheduling, estimates, invoicing — for $19.99/month.